Home » Articles and guides » RS and RKO rules

RS and RKO rules: practical application

Two radars: coordinating both antenna installations

One radar is already operating aboard the vessel and a nearby support has been selected for a second. Before ordering, consider both installations together: their antennas, relative positions, surrounding structures and intended simultaneous operation. Discussing only the new scanner leaves half the necessary information out of the enquiry.

As a specific position of the catalog can be discussed KODEN MDC-7912P. However, the radar model does not determine its position relative to another radar. Equally precise information is needed for the other installation, even if all its equipment will be retained.

Author's drawing of two spaced in height antenna stations radar on the superstructure of the ship
Original editorial illustration. The layout is schematic; the drawing specifies no installation dimensions and does not depict a particular product version.

For which area the example is given

This guide covers clauses 4.2.3–4.2.6 of Part V, Navigation Equipment, of the RS Rules for the Equipment of Sea-Going Ships, version 01.01.2026. Under clause 1.1.1, the scope is self-propelled ships not engaged on international voyages and equipment intended for them. The required equipment and applicable requirements for a particular vessel must be established separately. This article does not prescribe two radars for every vessel.

The overall objective is to review and avoid mutual interference

Clause 4.2.3 requires the positions of two antennas to be selected to minimise shadow sectors and prevent mutual interference during simultaneous operation. Clauses 4.2.5–4.2.6 address reflecting structures and proximity to other emission sources and radio-equipment antennas.

Prepare one layout showing all relevant equipment, rather than two unrelated drawings. Show both radar antennas, masts, platforms, major obstructions and nearby transmitting antennas. Exact equipment designations and documentation are also required: two scanners looking similar does not establish the conditions for operating them together.

When the clause specifies 20 degrees and one metre

For two antennas installed in close proximity, clause 4.2.4 specifies minimum separation in the vertical plane: an angle of 20° and a distance between the antennas of 1 m. The close-proximity condition applies specifically to the situation covered by that clause.

These figures do not make any pair of supports a complete design solution. First establish the actual antenna geometry, manufacturer's documentation and other applicable requirements. A photograph suggesting 'they look more than a metre apart' does not describe angular separation or demonstrate compliance with the entire section.

Two columns in the source data

What to listFor each of the two installations
Radar and configurationModels of the system, scanner and other units to be retained
Position of the antennaPlace on the general plan, height, surrounding structures
ExploitationIntended simultaneous operation and existing observations
Changes in changesNew supply, relocation or retention of each assembly
DocumentsAvailable diagrams, manuals and coverage information

The table helps prepare an enquiry by separating known facts from matters still to be resolved in the design. Equipment selection and approval of the layout should be identified as separate items in the quotation.

If you buy an antenna, not a second station

There is a separate catalogue. Sperry Marine 65606/A. This item does not constitute a second complete radar. Confirm its full designation, suitability for the turning unit, mountings and package contents separately. Nor do two displays prove the presence of two independent radars: the actual installation structure must be described first.

When enquiring about a second radar, state exactly what will be retained from the first and attach a combined plan of both antenna locations. Ask for equipment, accessories, documentation and agreed work to be itemised. Confirming the availability and price of an item does not replace assessment of its location aboard the vessel.

Sources

Checked on 25.10.2026, Astana time: RS publication catalogue, version 01.01.2026 and bulletin No. 25-251297; Part V of the Rules for the Equipment of Sea-Going Ships1.1.1, 1.1.3, 4.2.3 to 4.2.6.

The author’s illustration is not a diagram of the antenna spread or an indication of the mounting dimensions. The layout is determined for a particular vessel and equipment.

Send project details for a quotation

All materials in the series