Kelvin Hughes CAE-A402/3: azimuth board separate from the drive

The Kelvin Hughes CAE-A402/3 is an azimuth board of marine radar. The full index, including /3, must be retained in the application and matched with the marking of the proposed assembly. The words “radar pay” do not define the replacement part.

Request a quote

Conditional illustration of a printed circuit board, not a photo by Kelvin Hughes CAE-A402/3
Staff illustration of the type of product. The location of components, connectors and the state of a particular CAE-A402/3 is not determined by it.

How the manufacturer is installed

In the factory manual KH1207, Chapter 7, Table 5 Assembly of Transceiver CTX-A363 (10kW), ASSY line. OF AZIMUTH PCB contains CAE-A402/3 in the column Kelvin Hughes Part No. This is the basis for the position name. In our card, the previous signature of Sperry Marine has been corrected to Kelvin Hughes and the reference to the manual has been replaced by the corresponding statement.

The manufacturer of the board and the seller of the warehouse product are different information. The quotation requires a designation from the board itself: in case of discrepancy with the catalog line, the approval is performed before the reserve and shipment.

CAE-A402/3 and CAE-A236 perform different tasks

On the system circuit. KH1207 azimuth CAE-A402/3 shown separately Brushless Motor PCB CAE-A236. The receiver is also separately marked. CTX-C356 and terminal CTX-A368. Ordering one of these board does not mean supplying the other nodes.

Therefore, the description of the malfunction “antenna rotates, but the image is incorrect” or “antenna does not rotate” does not in itself confirm the choice of CAE-A402/3. The request is accompanied by the conclusion of the service or the results of diagnostics of the installed equipment. For one symptomatology, it is impossible to promise the elimination of a malfunction by replacing this board.

What to check before quotation

  • CAE-A402/3 assembly marking in its entirety and individual revision markings if present.
  • The type and serial number of the transceiver in which the replacement is provided.
  • Photos of both sides of the proposed board, connectors and markings.
  • Traces of repair, condition of connectors and actual completeness.
  • The agreed method of verification and what functions it confirms.

The number on the bare printed circuit board, the assembly sticker and the revision can describe different levels of the product. They are fixed separately; a similar wiring or matching part of the number does not prove interchangeability. KH1207 confirms this factory position, but not universally applicable to all Kelvin Hughes radars.

Accepting a used board

The Used mark means a former product in use. The quotation should contain information about the selected copy: identification, detected features, the scope of verification and acceptance conditions. External inspection does not replace functional verification, and inspection of the board separately from the marine system does not confirm the serviceability of the entire radar.

To order, keep the wording “Kelvin Hughes CAE-A402/3 azimuth board”. If you need additional nodes, list each in a separate line. So the specification doesn't turn one warehouse board into an indefinite set of electronics.

Card and documents

Supply and coordination

The CAE-A402/3 card shows two boards in Used state and the price is indicated on the product card. The balance, condition of a particular instance, reserve and value are confirmed by quotation.

Price and term - by quotation for the agreed composition. Specify the port or city, the required date, documents and method of acceptance. A mark in the catalog helps to select a position for the request; the actual balance and reserve are confirmed before the order.

Request a quote

Select a different theme for the technical guide