SKANTI TRP3024: TU3000 unit, CU3000 handset and DSC3000 connection
The SKANTI TRP3024 is being searched for as a separate transceiver for an existing post. Manufacturer: Skandinavisk Teleindustri SKANTI A/S In the archive record, the model is given in full: VHF-3000-TRP-3024. For replacement, it is useful to separate the block itself, the retained management and the DSC requirements to agree on the desired scope of supply.
TU3000 and CU3000 perform different tasks
Depot Handbook 910 000 89, Issue A1, section A-3, describes the TU3000 as a transceiver unit that houses the main radio tracks and system configuration, including the channels and the SelCall number. The CU3000 is a separate control handset with a keyboard and display. Therefore, ordering TU and ordering a full post differ in composition.
If an existing handset remains, specify its model and the condition of the connecting cable. If you need the entire post, list the required accessories in separate lines. A photograph of the general view of the operating unit helps to agree on the composition, but does not replace the readable marking of the unit to be removed.
Configuration 3024: Power supply reconciliation
Section A-4 assigns VHF3024 to configuration 24 B DC; VHF3012 by 12 V is separately described. In family designations, numbers are important: external similarity is not enough to choose a replacement.
The quotation should record the full designation TRP3024 and the power supply data of a particular instance. If the source block has a different marking, the approval begins with it, and not with the abbreviated “SKANTI 3000”.
When saving the DSC3000, you need a serial number and a TU version.
Manufacturer bulletin 009 650 92 A dated September 1993 separately addresses VHF3000 with DSC3000 Controller/Receiver. For serial numbers below 13401, it specifies conditions concerning TU software version, channel 70 settings and control-panel priorities. A transceiver alone does not establish readiness of the complete DSC station.
If the DSC3000 remains on the ship, include it in the task description. The service will need a serial number and version of the installed TU, information about remotes and applicable documentation. These data allow for the coordination of a specific bundle check prior to delivery. It is not necessary to reconfigure the short catalog text.
What to include in the replacement request
Indicate whether only a transceiver is needed or whether control and cables are also needed; attach the available labeling. Separately identify the retained DSC controller and the required verification. In the response quotation, the exact product, condition, agreed composition and the result of the inspection relating to the proposed instance must be understood.
The BOE archive record is used herein only to identify the model name. It does not confirm the valid approval or documents of a particular warehouse product; the required documents are listed separately in the request.
Card and documents
- SKANTI TRP3024 in the RadarStation catalog
- SKANTI: VHF3000 Depot Handbook 910 000 89, Issue A1, April 1997, sections A-3–A-4
- SKANTI: Technical Information 009 650 92 A, September 1993, VHF3000 installations with DSC3000
- BOE Archive, 1991: full designation VHF-3000-TRP-3024, only historical model identification
Supply and coordination
TRP 3024’s own card shows Used · 2 and the price in the product card. This is the account line of the transceiver; the handset, DSC controller, cables and other accessories are not included in the set by one name. The status, actual reserve and quotation composition are confirmed separately.
Price and term - by quotation for the agreed composition. Specify the port or city, the required date, documents and method of acceptance. A mark in the catalog helps to select a position for the request; the actual balance and reserve are confirmed before the order.