Sperry Marine T65801813: input board and reverse-compatibility restrictions

Sperry T65801813 is presented as the input board of the antenna receiver unit. When selecting, it is useful to check not only the coincidence of the number, but also the direction of the allowed replacement of the old configuration. The documentation contains a note that cannot be converted into a general rule of "both numbers replace each other."

Request a quote

Schematic illustration of a node type is not a photograph of a sold instance
Schematic illustration from the RadarStation catalog. Please request photos of the actual copy or package before ordering.

What is stated in the BridgeMaster E manual

The INPUT PCB ASSEMBLY (MASTHEAD TRANSCEIVER) list of 65800010B lists either T65801804 or T65801813. The note allows you to replace 65801804 with T65801813, but for the installed 65801813 requires a replacement with T65801813. This is an example of an asymmetrical rule: a one-way resolution does not confirm a reverse replacement.

This note applies to those listed in the configuration manual. For a particular block, it is necessary to verify its full designation, set board and current service documentation. Having a similar number in another radar table does not in itself extend the permitted applicability.

Why is the full block designation important?

The directory description may contain the abbreviation Aloft X-B, while the manual lists should be read along with the section heading and hardware configuration. Therefore, in the request it is useful to attach the number of the receiver unit as a whole. It helps to determine what configuration the required entrance board belongs to.

  • Radar model and full designation of the serviced unit.
  • Article, suffix and revision of the board to be withdrawn.
  • Service basis for replacement and the applied version of documentation.
  • Required new entry number and justification for proposed replacements.
  • Status, verification and precise scope of supply.

Do not confuse the entrance board with the filter

T65801818 is listed separately as RECEIVER FILTER PCB ASSEMBLY. This is another position for which there is receiver-card. The power supply network input filter is also a separate task. The common words Input or Filter in the title do not make these products a single spare part.

If the desired node is not yet determined by the service, describe the observed failure and the checks performed, instead of selecting a board for one word in the description. The quotation must be clear about the specific element to be replaced.

Confirm the proposed replacement before payment

Ask for confirmation of applicability, taking into account the article and direction of replacement. Separately coordinate the state of the instance, recovery work, if necessary, and the verified result after installation. The similarity of the board in the photo does not replace this alignment.

Full labeling in the query will help to keep the limitation of documentation and get a quotation for the desired configuration T65801813, rather than the seemingly similar old position.

Card and documents

Supply and coordination

T65801813 catalogues two in-service specimens and one for restoration. The condition, applicability and readiness of a particular copy is confirmed before ordering.

Price and term - by quotation for the agreed composition. Specify the port or city, the required date, documents and method of acceptance. A mark in the catalog helps to select a position for the request; the actual balance and reserve are confirmed before the order.

Request a quote

Select a different theme for the technical guide