Sperry Marine T65801801 and T65801822: trigger-board version

When ordering the T65801801, the name “Sperry trigger board” does not yet define the configuration. There is a separate entry T65801822 on the factory list for a part of the transceivers. Therefore, first compare the full designation of the installed block and the number of the board.

Request a quote

Conditional diagram of the printed circuit board, not depicting the location of the components T65801801
General node type scheme from the RadarStation directory. It does not show the location of the T65801801 components and is not intended to verify compatibility.

Two lines for different configurations

In the manual Sperry Marine VisionMaster 65900011section 4.4.2 chapter 7for standard X-band Turning Units and Transceivers indicated T65801801. Next line for blocks with symbols 658xxP, 658xxG and 658xxPyy given T65801822. It is a distinction within the statement, not permission to arbitrarily change these board.

You can not discard the letters after the numerical part of the marking and leave only the power or name of the radar family. For purchase, keep the designation in its entirety: it must match the configuration the service has identified the replacement position.

Additional functions require their own table

Chapter 11 of the same guide for Additional Features systems provides a separate statement of boards. It contains T65801803, T65801806 and T65801825; T65801801 is also present in its configuration column. The coincidence of the Trigger Board’s purpose doesn’t make all of these numbers a universal replacement.

If the quotation specifies another index, ask for the basis of applicability to your block. The general promise of “suitable for VisionMaster” leaves open the question of a specific configuration. The replacement decision should be based on the service documentation and the actual configuration of the installation.

What to include in the request

  • Full designation of the transceiver or antenna post with a nameplate.
  • Full number and revision of the board being removed; photos of its marking.
  • Service conclusion with the number of the required spare part.
  • Permissible condition of the product and the composition of the inspection before shipment.
  • Whether you only need a spare board or also repair and replacement work.

Po Po entrance board T65801813 and filter board T65801818 There are separate technical guides. Their names should not be transferred to the trigger board application: the specification must remain a specific node specified for repair.

Warehouse copy and acceptance

Agree which copy is offered, its condition and documented verification. For the position under restoration, the scope of work and the period of readiness are determined separately. The catalog quantity does not replace the reserve confirmation, and the general board scheme does not confirm the condition of the product.

Card and documents

Supply and coordination

T65801801 indicates two in-service and one for restoration. the price is indicated on the product card; the applicability, actual condition, reserve, price and readiness of the particular instance are confirmed by quotation. The recovery copy is not declared ready for installation.

Price and term - by quotation for the agreed composition. Specify the port or city, the required date, documents and method of acceptance. A mark in the catalog helps to select a position for the request; the actual balance and reserve are confirmed before the order.

Request a quote

Select a different theme for the technical guide